Sorry for the lack of updates on this project so far - I finally got into some making this afternoon.
So basically I went to the hardware store and bought a couple different sections of piping that seemed fruitful. Although the copper piping looked very intriguing and felt great to hold and interact with, I ended up pursing the PVC this afternoon because copper is conductive and I felt it was too risky to move forward with.
In my modeling last week, I basically came to the conclusion that my photocells should all be adhered to one common base that I would slide/insert into the center of the pipe to hold them in place underneath the holes. I've attached pictures of some perf board that I cut and wired my photocells and mux onto today!
top:
bottom:
side-by-side with pipe:
photocells through pipe holes:
No comments :
Post a Comment
Note: Only a member of this blog may post a comment.